Once you line up the template (or level) to the drawer, you’ll need to make a small mark so you know where to drill when you move the template. Photo Credit: “ pencil” by Tim Taylor is licensed under CC BY 2.0 (Also, see step 1 below for another tip to avoid measuring). Tell an employee that you want the same size screw diameter, but longer or shorter length, depending on the thickness of your drawer and the depth of the screw hole in your pulls. If that’s the case, just measure the thickness of your drawer and go to your local hardware store with your pulls and the screws that it comes with. But keep in mind that depending on the thickness of your drawers or cabinet doors, you may need longer or shorter screws than what is provided. Oftentimes, when you buy the cup pulls, the necessary screws come with them. ![]() Obviously, you’ll need the actual cup pulls and screws. But I’m telling you, it’s worth it! You can even make a homemade template using a paper, pencil, and ruler. ![]() You can use a level if you absolutely need to or can't spend a few bucks on the template. And it even comes with a standard drill bit. It saves you from doing some measuring and basic math, which is quite the perk for someone like me who is horrible at math. This handy template will make your life so easy while you install your cup pulls! As a side note, it also works for pulls, knobs, and handles. ![]() Most likely it will be a Phillips head (aka cross-head) tip. Then you’ll also want the drill bit that fits the type of screws you’ll be using. You’ll probably want a standard drill bit to make the original hole. Kitchen Pull-Out and Built-In Trash Cans.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |